Allen-Bradley Overview
TheALLEN_BRADLEY route enables communication with Rockwell Automation PLCs using native protocols. It supports ControlLogix, CompactLogix, PLC5, SLC500, Micro800, and MicroLogix families with TAG-based addressing and bidirectional communication.
Basic Syntax
Supported Device Families
ControlLogix (0) is the most common setting for modern Allen-Bradley systems including CompactLogix and ControlLogix PLCs.
Connection Configuration
ALLEN_BRADLEY_CONFIG Parameters
Routing path for accessing PLCs through network infrastructure. Format:
port,slot pairs separated by commas.Connection Examples
- ControlLogix/CompactLogix
- MicroLogix
- Through Backplane
- Multi-Hop Routing
Direct connection to ControlLogix or CompactLogix:
Tag Addressing
Allen-Bradley uses symbolic tag names. The address format depends on the tag scope:Data Types
TAG Configuration
Complete TAG Example
TAG Parameters
Address Configuration
Address Configuration
Value Transformation
Value Transformation
Filtering
Filtering
Publishing
Publishing
Event-Based Operations
For on-demand Allen-Bradley operations (not polling), use the EVENT syntax. Publish a message to SOURCE_TOPIC to trigger the operation; the route executes it and publishes the result to DESTINATION_TOPIC.Supported Operations
Query Parameters
Read Example
Read a program-scoped counter on demand:Write Example
Write a REAL setpoint on demand:Complete Examples
- Basic Tag Reading
- UDT Members
- Array Access
- Bidirectional Control
- CompactLogix
- Combined (Cyclic + On-Demand)
Read controller-scoped tags:
Troubleshooting
Connection Failed
Connection Failed
- Verify IP address is correct
- Check DEVICE_FAMILY matches your PLC type
- Ensure SLOT is correct (usually 0 for CompactLogix)
- Verify firewall allows port 44818
- Check PLC is in Run mode
Tag Not Found
Tag Not Found
- Verify tag name matches exactly (case-sensitive)
- For program-scoped tags, include program name:
MainProgram:TagName - Check tag exists in PLC project
- Ensure tag is not local to a routine
Path Errors
Path Errors
- Verify PATH format: port,slot pairs
- Check network modules are configured correctly
- For IP in path, use:
port,slot,port,IP,port,slot - Increase TIMEOUT for multi-hop routes
Write Operations Fail
Write Operations Fail
- Ensure WRITABLE is set to “true”
- Verify PLC is in Remote Run mode
- Check tag is not constant or read-only
- Verify value is within data type range
Data Type Mismatch
Data Type Mismatch
- Verify DATA_TYPE matches PLC tag definition
- REAL for floating point, DINT for 32-bit integers
- Check array vs. single value configuration
Next Steps
EtherNet/IP
CIP explicit messaging for Allen-Bradley and compatible devices.
Industrial Overview
Common patterns for all industrial routes.

